7) Parametrization
7) Parametrization
For easier prarametrization, the parameter set is divides into 11 parameter groups:
Parameter type
Parameter Nr. Range
Gruppe
BASIC parameters
F100 - F160
100
Inverter control, set-point origin setup
F200 - F230
200
Function assignation to digital I/Os - diagnosis
F300 - F330
300
Analogue I/O signal configuration
F400 - F473
400
Fixed-frequency control, cycle control
F500 - F572
500
DC-Brake, limiting functions, auxiliary functions
F600 - F623
600
Fault handling – configuration of protection function
F700 - F740
700
Motorparameter, AUTOTUNING
F800 - F830
800
Serial link parameter set
F900 - F930
900
PID controller parameter, pump control functions
FA00 - FA30
A00
Selection of parameters, modification and saving:
The key toggles between all different values on the display.
F
prefix indicates parameter level and the number refers to a configuring parameter.
Once on parameter level, the keys are used to flip through parameters.
key toggles between single and multi parameter step. If is on, single mode is
selected, if off, group mode is selected, and keys moves in steps of 100.
key selects the parameter on the display, and the parameter value is shown. The blinking
digit may be changed, using keys (eventually use key to switch through single
digits). Pressing again memorizes the modified parameter value.
Parameter types:
Read only parameters:
These parameters can not be changed, the tentative to modify will end up in
Err1
message – read-only
parameters are listed in
GRAY
characters
Dynamic parameters:
These parameters are allowed to modify with inverter in
START
and in
STOP
mode, listed in red bold
characters on this description:
Fxxx
Static parameters:
To modify with inverter in
STOP
mode only, otherwise,
Err1
is displayed, static parameters are listed in red,
italic bold characters as
Fxxx
E800 – Rev.01 –EN-SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
- 31 -
