11
To unfold the bicycle rack, start by swinging out the rear lights. Swing
the light carrier out completely (Fig. 12) until you feel it engage. The
light carrier is now secured against folding in.
5.3 DISMANTLING THE BICYCLE RACK
Figure 13: Swinging out the lamp holder
Fold open the bicycle rack as shown in the following Figures.
Figure 14: Raising the U-bracket
Figure 15: Fold out the right rear light
Figure 16: Fold out the left rear light
Figure 17: Fold out the right wheel rail
Insert the short tensioning strap from the inside to the outside below the
bike holder and then from the outside to the inside through the slots of the
bike holder (Figure 20). For the rear wheel of the bicycle, use the centre
slot of the wheel holder, for the front wheel, use the two outer slots (two
tensioning straps to prevent the front wheel from turning).
5.4 MOUNTING THE SHORT TENSIONING STRAPS
Figure 19: 3 x short tensioning strap
Figure 20: Assembly tension strap
Place the fi rst bicycle in the fi rst bicycle rail and secure it to the U-bolt
with the frame holder. You attach the wheels by placing the tension straps
around the rim of your bicycle and tighten the straps. Attention: The front
wheel must be secured against twisting with two small tension straps.
straps to prevent it from turning (Fig. 21). Now secure the bicycle with the
long safety belt. Place the safety belt through the bicycle frame and around
the U-bolt and tighten the safety belt fi rmly. (see picture 22)
5.5 MOUNTING THE BICYCLES TO THE REAR RACK
Figure 21: Tensioning straps for front wheel
Without this safety strap, the bicycle rack may not be
used.
Figure 18: Fold out the left wheel rail
Figure 22: Safety strap
Safety strap
5.6 FOLDING THE BIKE RACK
Figure 23: Folding in the rear lights
First fold the wheel rails back onto the rack table. Push the locking
mechanism of the rear lights (Position 1 in Figure 23) outwards, and then
swivel the light mount back (Position 2 in Figure 23). Proceed accordingly
on the other side of the rack.
In order to store the bicycle rack as fl atly as possible, you can also fold the
U-shaped bracket down.To do this, release the two quick-release levers