Eudora GSI 6104 Manual Download Page 5

Page: 5 / 24

12345678901

1) ON/OFF On/off button Press this button to switch the appliance on
2) Low salt indicator light (if fitted)
3) Low rinse aid indicator light (if fitted)
4) “Delay” delayed start selector
5) Quick wash selector
6) Programme selector button
7) Multifunctional display
To open the door, pull forwards (an electrical safety device will switch the machine off when the door is opened).

Start-up

After checking the quantity of salt (only in models with salt compartment) and rinse aid, open the water inlet valve completely,
place the crockery in the racks, pour the main wash detergent and pre-wash detergent (if necessary) into the compartment
and close the door at the front of the machine.
Proceed as follows:
• Activate the “on-off” button ; the display will light up and show the most recent programme performed.

Programme selection

• Press button

(programme selector) to display the washing symbol above/below ( ) and after approximately 3

seconds the duration time for the selected programme will appear. Every time button

is pressed, the following programme

is selected.
Select the programme most suited to the type of crockery to be washed.
At this point the machine is ready to start the wash programme.

Start

• Close the door; after the beep signalling the start of the programme the dishwasher performs the wash cycle automatically.
Note: To display details of the programme in progress, press the programme selector button

; this will display the type of

programme currently in progress for 5 seconds.

Incorrect programme settings (changing the programme or using RESET)

• To modify a programme which is already in progress open the door and press the Programme selector button

for

approximately 6 seconds. A scrolling segment on the Display indicates the machine is in reset mode. Close the door immediately.
N.B. The buzzer sounds to confirm the end of the RESET, and the text “End” is shown on the display. At this point the
machine is ready to be set again.
• If you have forgotten to place something inside the machine, the wash cycle may be paused (preferably only if the programme
started a short time before): open the door and place the crockery inside. To restart the machine, close the door; the cycle will
start from the point at which it was interrupted.
• To repeat the wash, confirm the displayed programme by pressing the programme selector button

and close the door.

NOTE: if the power supply is suddenly cut off, the wash programme will restart from the point at which it was
interrupted.

Stopping the machine

At the end of the cycle the dishwasher stops automatically and 3 beeps sound three times to confirm the end of the wash
cycle. The text “End” appears on the Display; when the door is opened the Display lights up and the text is shown for
a further 10 seconds, after which the number of the most recent programme performed remains visible.

To switch off the machine, press the on/off button

. After each wash cycle, close the water inlet completely to cut off the

dishwasher from the water supply network.

ADVICE: After the beeps signalling the end of the cycle, to accelerate the drying phase the door may be left ajar.

18a