INSTALLING BEAN HOPPER
Fig. 1
NOTE:
Hopper should be cleaned daily as coffee oil residues can have a negative
effect on the taste of your coffee. Once empty and removed (acc. to our
instructions), hopper and lid may be washed in warm soapy water. Rinse and dry
thoroughly.
PORTAFILTER HOLDER (Espresso) / PLATFORM (Filter)
Carefully unpack grinder and verify delivery contents according to attached list.
Clean all loose parts with a soft damp cloth and allow to dry completely before use.
GETTING STARTED
Fig. 2
ATTENTION
(W-versions only): Be careful not to bend the center hook by applying
too much force thus damaging the loadcell.
Fig. 6
Push both locking levers rearwards
(arrow direction OPEN, Fig. 1).
Position hopper (bean-blocker handle to the right) at
intended opening.
Close locking levers and rotate bean-blocker by 180°
into OPEN-position (Fig. 2).
Fill in the beans and close lid.
Fig. 5
Fig. 3
Fig. 4
Use your index finger to press against the rear part part of the upper holding arm
(Fig. 3) while sliding the arm in position with your thumb – up/down (Fig. 4).
Once adjusted, insert the portafilter holder / platform (Fig. 6) onto the center hook
(Fig. 5) and
slide it rearwards as far as it will go.
REMOVING BEAN HOPPER
Close bean-blocker handle by turning it to the front. Open locking levers. Lift off
hopper and place it on its lid.
Grinder Motor will not turn on with hopper removed!
