Manufacturer
Distributor
7
Figure 4. Connecting the Adapter
If the
vehicle’s instrument
panel does not have a sufficient number of input terminals for connecting the
required number of fuel level sensors, the readings of several sensors may be combined (Fig. 5) using a summator
(see
Operating Manual for Summator ETS 3.0
).
IMPORTANT NOTE:
Where the readings of several sensors are to be combined, frequency-based sensors (Fuel
Level Sensor ETS.F, available from the manufacturer) must be used, the output signal of the summator being
a voltage in the range of
0…
10 V.
5.3
Connection
Figure 5. Connecting the Summator ETS 3.0
Connector Pin Designations
Pin Number
Designation
Wire Colour
Summary of Contents for ETS.A
Page 1: ...Fuel Level Sensor ETS A Operating Manual...
Page 9: ...Manufacturer www ets by by Distributor www metrotec ee 9 Legend...
Page 19: ...Manufacturer www ets by by Distributor www metrotec ee 19 Figure 24 Voltage of Sensor When Dry...
Page 24: ...Manufacturer www ets by by Distributor www metrotec ee 24...
