Images are for illustrative purposes.
We reserve the right to make changes.
7
®
RDM-31-0222
NORD
canopy
|
OZ 3.0 Installation Guide
4.2 Connect the pressure measurement hoses
For an Ozone Module to operate properly its two pressure measurement hoses must be connected.
- Two hoses, one long and one short, are provided in the shipping carton. Feed the long hose through the
Ø100mm ozone duct into the exhaust chamber.
- While lifting the module into place, securely attach one end of the hose to the hose located in the Ozone
Module 100mm flange. Raise the module into place, gently pulling the hose from its other end to ensure it
does not become kinked or disconnected in the process.
- Secure the 4 fixing clamps to fasten the module to the inside roof of the canopy. Clip off the excess hose
as shown in the diagram.
Note the location of the pressure nipple near the module mounting bracket inside the canopy. Securely attach
the shorter hose between the nipples on the module and the canopy.
NOTE!
There are two hoses that need to be connected to each module.
20cm
2.
3.
1.
