
www.ets-lindgren.com
Operation
25
Remote Control via the IEC/IEEE-488.2 GPIB Interface
The instrument is equipped with an IEC-Bus connection. The connector according to
IEEE 488 is located at the rear panel of the instrument. This interface can be used to
connect a controller for remote control purposes. The connection must be made using
a shielded cable.
Characteristics of the IEC/IEEE.2 GPIB interface:
8 bit parallel data transfer
Bidirectional data transfer
Three wire handshake
High data transfer rate
Up to 15 instruments can be connected
Maximum length of interconnection cables 15 m (each single connection 2 m)
DI/0
DI/0
2
4
IFC
NDAC
EOI
1
DI/0
DI/0
DI/0
3
NRFD
DAV
1
2
3
4
13
14 15
16
5
6
7
8
17
18
19
20
SHIELD
ATN
SRQ
9
10
11 12
21
22
23
24
9
GND
GND
DI/0
DI/0
GND
REN
5
6
DI/0
7
8
7
GND
6
8
Logic
GND
GND
11
10
GND
Figure 7: Pin assignment of IEEE connector
On power on, the amplifier is always in the local state (manual operation). At the front
panel display LOCAL will be indicated.
If a controller addresses the amplifier as a listener by sending the REMOTE
command, the amplifier changes to the remote state and remains in this state even
after termination of data transmission. This is indicated by the message GPIB at the
front panel display.
A change of the control mode is only possible when the amplifier is in STANDBY
mode.
Summary of Contents for 8100-040
