ETS-Lindgren 8100-040, User Manual, Page: 21 / 44

www.ets-lindgren.com Operation
21
Manual Operation
Press the MAINS switch to turn on the amplifier.
The MAINS switch is illuminated. Only the main control board is supplied and
the turn-on procedure of the instrument is executed.
The model number will be shown in the power up screen on the display
(Screen P).
After 2 seconds the amplifier will change the display to its main screen
(Screen M).
The amplifier is now in standby and in the local control mode
(Display:LOCAL).
In this state the amplifier offers a user menu, which allows viewing
miscellaneous diagnostic parameters of the instrument and allows adjusting
of the IEEE address.
The following description refers to Figure 6: User Menu on a page 23 which gives an
overview of the user menu pages:
From the main screen, the user menu can be accessed by pushing the left
and the right button simultaneously for at least one second.
The first page of the user menu is the voltage and current page (Screen V).

It is primarily intended for diagnostics (e.g. during checking or
service) and shows the actual voltage and current values of all the
internal power supply output channels of the instrument.

By clicking the left or right button the previous or next supply channel
can be monitored.

Exit the voltage and current page by pushing the left and the right
button simultaneously for at least one second.
The second page of the user menu is the amplifier identification screen
(Screen I).

This screen shows the type and serial number of the amplifier (same
as the remote control
command “*IDN?” will respond).

Exit the amplifier identification page by pushing the left and the right
button simultaneously for at least one second.