LUNA 24
CHOOSING OPERATING MODES
LUNA 24 can be operated in 4 different ways for different tasks.
Operating mode 1: 2 Preset
With the faders of PRESET A and PRESET B you must first produce two different,
12 circuits
A-B - Operation
independent lighting scenes. Then you can mix MASTER A and MASTER B.
Operating mode 2: 1 Preset
The PRESET A-faders produce lighting scenes. The PRESET B-faders work as scene 12 circuits
12 Scene Masters masters. Complete lighting scenes can be stored and recalled through them.
Operating mode 3: 1 Preset
Use PRESET A to work on channels 1-12; use PRESET B to work on channels 13-24. 24 circuits
Crossfader
MASTER B is the „crossfader“ to mix stored lighting scenes.
Operating mode 4: 12 Scene Masters Faders of PRESET A can be used alternatively for circuit 1-12 or 13-24. Faders of
24 circuits
PRESET B work as scene masters. 24-Circuit scenes can be stored and recalled.
Installation of operating mode:
STEP
GO
STOP
BACK
CHASER
M O D E
FLASH
M O D E
AUDIO
M O D E
C H A N N E L S
SCENES
(ADD STEP)
DMX-PATCH
MIDI
1
PAGE
PROG
CH. 1-12
2
3
Installing
Press simultaneously MODIFY- and DBO-key.
selection mode:
MODIFY-LED is illuminated green. DBO-key is blinking.
Select operating
Display (far right side) shows operating mode by numbers 1 through 4.
mode:
Choose by using arrow-key below.
Switch off effect If you don’t need the effect program (chaser and audio-effects) you can turn them off. programs:
The number of available programs is shown in the middle of the display under PROG.
Choose
the program you need by using the arrow-key.
Zero means program number zero = first program.
A dash indicates that all effect programs are turned off.
Limit memory
Sometimes it might be helpful to reduce the number of available lighting scene banks. access:
Display shows right-hand under PAGE number 1-9.
Use arrow-key to select.
Invert MASTER B:
In operating mode 1 (the classical A-B mode) it might be helpful to mix or fade scenes
with
MASTER B inverted.
Use arrow-key above MASTER B to switch mode.
The Display shows „-“ = normal or „c“ = inverted.
Store settings:
Press STORE-key. It quits the selecting mode.
(If you press MODIFY-key you quit selecting mode without storing.)
Remarks:
Contents of limited or OFF-programs remain stored.
In every operating mode the same storing places are used.
So you can produce a scene in operating mode 3 and recall it in operating mode 4.
ESCAPE
MODIFY
+
DBO
1
2
3
3
STORE
CHOOSING OPERATING MODES
