EN 33
Setting the adjustable levelling feet
1. Before you fit the washing machine, check that the adjustable
levelling feet are in their original position, tightened as far into the
machine as possible. If this is not the case, you need to tighten
them by hand or with a spanner.
2. After positioning the washing machine, push on the four corners on
the top of the washing machine in turn. If the machine shakes when
pressing one of the corners, the adjustable levelling foot needs to
be set under this corner.
3. Ensure that the washing machine is in the correct location. Loosen
the lock nut with the wrench and turn the adjustable levelling foot
by hand until it is touching the ground. With one hand push the
adjustable levelling foot against the ground, while the other hand is
tightening the locknut against the washing machine.
4. After levelling the washing machine, once again press on all four
corners to make sure that the washing machine is stable. If the
washing machine still wobbles, then repeat steps 2 and 3.
5. Place a cylindrical object (e.g. a fizzy drinks can), so that it is
lying on the top of the washing machine and aim it in all possible
directions. If the can does not move, then the washing machine
is level. If it rolls, then the washing machine is at an angle. The
direction in which the can starts to roll is towards the lower surface.
Where this is the case, both adjustable levelling feet should be
unscrewed on the same side until the washing machine is level.
Repeat steps 1 to 3, ensuring the adjustable levelling feet are
turned so that they are tight against the ground and the locking
nuts are properly tightened.
Connecting the fill hose
1. Connect the fill hose to the washing machine with the elbow
connection. Do not allow the fill hose to hang straight down, but
turn it to the left or the right. Tighten the hose fitting by hand only.
2. Then connect the straight connection to a water tap with an R 3/4
(inch) screw thread. Attention! Only tighten the hose coupling by
hand.
3. Before commissioning the machine, check that the connection is
tight by slowly opening the water tap.
max. 1 cm
INSTALLATION
