Etco IP-Mini, Instruction Manual

Page: 14 / 29

ETCO Incorporated, Tel: 401-467-2400 Fax: 401-467-9230 Web: www.etco.com
1 1
INSTALL APPLICATOR CONTINUED
24
Rotate Power Switch to
ON
position and then press
RESET
button.
Note: You must press
RESET
button
each time you turn on the press.
25
Press yellow
JOG
button until
press makes ONE complete
revolution. While press is
jogging, observe Applicator for
proper functions – part feeding,
crimping, cut-off, etc.
26
Insert wire over anvil just
touching cut-off pad. Depress
foot pedal once to cycle press
under power.
Note: Repeat steps
25
and
26
,
three to six times.
– Inspect sample terminations
for proper crimping and cut-off.
SECTION 1
INSTALL AND SET-UP INSTRUCTIONS
ETCO IP MINI REAR FEED APPLICATOR – page 9