ETC Sensor+ HSR+ Series, Retro-Fit Manual

Page: 3 / 16

Introduction 1
Introduction
This manual is intended to guide ETC Service Technicians
through the process of upgrading existing
enclosure installations to Sensor3 enclosures with a CEM3
control module. This manual covers SR+ or HSR+ 6, 12, 24
and 48 permanent installation enclosures.
If you purchased this retrofit kit as part of a power
package, see
support.etcconnect.com/Source_Articles/
ETC/Power_Controls/General/ETC_Upgrades_Program or
scan the QR code to the right for more information.
Overview of this Manual
•
Preparation (page 5)
: Before you open the enclosure
• Remove the Old CEM (page 6) : Label and remove the existing equipment
•
Attach New Power Harness (page 7)
: Adapt and connect the power harness for the new
backplane
• Install the New Backplane (page 9) : Transfer the wiring and install new components
•
Change out the AF Cards (if present) (page 11)
: Remove the existing Advanced Feature cards and
install the new ones
• Change out the Beacon PCB (page 11) : Replace the existing beacon primary circuit board (PCB)
with the new one
•
Enclosure Door (page 12)
: Replace the beacon acrylic in the door and replace the enclosure label
• Verify the Retrofit (page 12) : Put the dimmers back in the enclosure and power up the enclosure
•
Configure the CEM3 (page 13)
: Program a configuration for the CEM3
• Final Steps (page 13) : Clean up waste and archive CEM3 configuration