36
Inspire Station Programming Guide
Remove or Install the Wall Plate
Remove Wall Plate
After station installation is complete, to gain further access to the
features and set the station
, you must first remove the station wall plate.
The wall plate is secured to the station with magnets that are attached to the wall plate.
Step 1: Using your index finger and thumb, lift the left and right side edges of the bottom
of the wall plate, disengaging the magnets. The magnets that secure the wall plate
are strong. You will need a good grip on the plate to lift it away.
Step 2: When the bottom of the wall plate is free from the magnets, continue lifting until the
top of the plate is free from the tabs on the top of the station electronics assembly.
Install Wall Plate
Note:
When installing a multi-gang wall plate to a station and the stations are not
aligned properly in the back box, the wall plate will not attach properly.
Loosen the screws that secure the station to the backbox, adjust each station
to improve the alignment, secure the screws, then retry wall plate
installation.
Step 1: Align the top of the wall plate to the station and
angle the bottom approximately 20 degrees.
Step 2: Hook the top of the wall plate to the tabs located on
the station electronics assembly. To ensure the wall
plate is hooked properly on the top hook, wiggle it
slightly side to side.
Step 3: Swing the bottom of the wall plate down until the
magnets engage.
Step 4: If the wall plate does not fully attach automatically,
wiggle the bottom of the plate until all of the
magnets are seated properly to the station and the
plate is secure.
