ETC Installation Guide
ColorSource Linear v1.7
Installation
Mounting
The ColorSource Linear ships with a pair of floor trunnions for mounting.
Note:
Ensure that the trunnions are installed with the feet inward so
that fixtures can be lined up end-to-end, if needed.
You also have the option of using clamps with the trunnions to hang the
fixture. Attach the clamps to the holes in the trunnion feet (see figure on
).
The ColorSource Linear 1 has two additional mounting options. Contact your
local dealer for more information.
•
Yoke with C-clamp (7414K1017)
•
Double yoke with C-clamp for mounting two fixtures (7414K1018)
C-clamp
attachment
point
Safety cable
anchor point
Cutout for
cable strain relief
Safety Cable
Two safety cable anchor points are
provided on the fixture housing.
The anchor points also include two
cutouts that can be used for cable strain
relief.
Connectors
•
Power: Two powerCON
®
connectors for power in and thru
•
Data (DMX512/RDM): Two five-
pin XLR connectors OR two
RJ45 connectors for data in and
thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Connector locations
•
Linear 1: Power connectors on one side of the fixture and data
connectors on the other
•
Linear 2 and Linear 4: Power and data connectors on each end (to
facilitate daisy-chaining)
Note:
This fixture is not Ethernet/data network compatible.
ColorSource Linear
Page 5 of 20
ETC
