ETC ArcSystem Pro D4 Series, Installation Manual, Page: 43 / 68

Emergency System One-Cell Installation 37
Wall-Mount D4 Emergency Driver 350 and 700
Wall-Mount D4 Emergency Driver 350 and 700 have push-in terminal blocks on the "Sense" and
"Maintain" inputs. No tools are required to insert wires into the terminal block. See
Push-In
Terminal Blocks on page 21 for an illustration of the push-in terminal blocks.
•
To install wire, insert the wire into the terminal.
•
To remove wire, insert a 3.5 mm flatblade screwdriver into the tool slot next to the wire
terminal to release the wire, then pull the wire out of the terminal.
Wall-Mount
D4 Emergency Driver 350/700
Sense and Maintained Input Detail
Factory Wire Colors
Model Color Type
North
America and
Europe
green/yellow
ground/earth
North
America
black line/hot
North
America
white neutral
Europe brown live
Europe blue neutral
1. Make sure power is off at the main circuit breaker.
2. See
Wire and Terminal Specifications on page 16 for specification of wire size and strip
length. Prepare the wires accordingly.
3. See
Push-In Terminal Blocks on page 21
for general instructions on using the push-in
terminal blocks.
4. Insert the ground wire (typically green) into the terminal marked "Maintain ."
5. Insert the neutral wire (typically white) into the terminal marked "Maintain N."
6. Terminate the line (hot) wire (typically black) into theterminal marked "Maintain L."
7. Tug gently on the wires to ensure they are secure.