12
Navis 100 Installation Guide
4.
Adjust the tilt and rotation of the luminaire to the approximate
final position and use a 2.0 mm hex key to tighten the yellow
locking screw on the base of the luminaire to secure the tilt and
rotation positions. Be careful not to over tighten the screw. (See
for the location of the locking screw.)
Note:
Setting the approximate tilt and rotation positions before
you install the luminaire minimizes the need for large adjustments
after the luminaire is installed, which helps prevent the cables
from twisting or wrapping around the luminaire.
5.
Connect a power and data in cable from the driver to the "In" port
on the luminaire. (See
for the
location of the ports.)
•
If you are daisy-chaining 2-4 luminaires, be careful to connect
the cables to the correct "In" and "Out" ports. (The cable from
the "Out" port on one luminaire connects to the "In" port of
the next luminaire.) Incorrect connections will result in
improper operation of the luminaires.
•
If you are installing RGBW luminaires, you must terminate the
last luminaire in the line. See
Wiring the Luminaires on page 6
for details.
6.
Insert the luminaire through the hole in the ceiling. If necessary,
rotate the luminaire so that the tilt and rotation of the luminaire
are oriented appropriately.
7.
Using a 2.0 mm hex key, tighten the silver screw on each of the
three clamps (see
for the locations of
the clamp screws). As you tighten each screw, the clamp will
automatically extend out to grip the ceiling. Be careful not to over
tighten the screws.
Note:
Navis 100 luminaire mounting clamps can accommodate
0.5–20 mm (1/32–3/4 in) ceiling thickness.
8.
Confirm that the tilt and rotation of the luminaire are correct. If
necessary, use the 2.0 mm hex key to loosen the yellow locking
screw, tilt and rotate the luminaire so it is focused to its final
resting position, and tighten the locking screw again.
9.
Attach the magnetic trim plate to the base of the luminaire. The
trim plate should be centered on the base of the luminaire and
should connect firmly to the three magnets.
