4
Navis 100 Installation Guide
Emergency System Overview
Navis 100 White and Fade to Warm luminaires, when powered by an F-Drive
W1 Emergency Driver, are compliant with or conform to the applicable
safety standards for emergency applications. For current and complete
compliance information, view the Navis 100 datasheet at
etcconnect.com/Products/Lighting-Fixtures/ArcSystem-
Navis/Documentation.aspx
. For emergency system information about the
driver, see the
F-Drive Series W1 Installation Manual.
Note:
The number of designated emergency lamps and their
height is the responsibility of the specifier and installer in order to
achieve the minimum FC levels of NFPA101. Installation scenarios
should be evaluated by the AHJ to confirm illuminance and
performance requirements of ANSI/NFPA 101 and the IBC.
Note:
Installation must follow all national and local codes for
electrical equipment.
Navis 100 Features
4
2
3
1
4
5
1
In Port
2
Out Port
3
Channel Rotary Switch*
4
Mounting Clamps (quantity 3)
5
Magnetic Trim Plate
* The channel rotary switch is only
present on RGBW luminaires.
A
A
A
B
C
C
C
View with trim plate removed
A
Three 2.0 mm hex head screws (silver)
for mounting clamps.
B
One 2.0 mm hex head screw (yellow) to
lock the tilt and rotation.
C Three magnets that secure the trim plate