EN
27
Class II machine – Double insulation –
You don’t need any earthed plug.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
3. ASSEMBLy
Use only sharp drills of the following types
Fig.B
Concrete/masonry Hard metal
Metal
HSS
Wood
HSS
Mounting accessories
Fig.C
Prior to mounting an accessory always
unplug the tool.
Placing and removing bits
In addition to bits the machine can also hold screw
bits with a hexagonal shaft.
Loosen the chuck by rotating the handgrip
•
(A).
Insert the drill/bit into the chuck.
•
Tighten the chuck so that the drill/bit is firmly
•
clamped.
4. USE
The On/Off switch
Fig.D
Switch the machine on by pressing the
triggerswitch (A). When you release the
triggerswitch (A) the machine will turn off.
Switch-lock
You can lock the On/Off switch by pressing
the triggerswitch (A) and then pressing knob
(B). Release the switch-lock by pressing the
triggerswitch (A) shortly.
Speed-control
The rotation-speed can be continuously adjusted
from 0 to 3000 rotations per minute by pressing
the switch (A) deeper or less deep.
Adjusting of the maximum rotation speed
Switch the machine on by pressing
•
triggerswitch (A).
Lock the triggerswitch (A) by pressing knob
•
(B).
Adjust the speed by turning the small wheel
•
(C) to the desired maximum rotation speed.
Switching the direction of rotation
Direction of rotation counter-clockwise: shift
•
switch (D) to “L”.
Direction of rotation clockwise: shift switch (D)
•
to “R”.
Switch for percussion drilling
Fig.E
With the switch on top of the machine you can
select normal or percussion drilling (7).
Slide the switch to the “Drill” symbol for
•
normal drilling.
Slide the switch to the “Hammer” symbol for
•
percussion drilling.
5. SERVICE & MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
The machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Clean the housing regularly with a soft cloth,
preferably every time it is used. Keep the
ventilating apertures free from dust and dirt.
Remove stubborn dirt with a soft rag moistened
