BR_XETK-S2.0 - User’s Guide
30
ETAS
Installation
5
Installation
In this chapter, the hardware installation of the ETK-T2.2G is described.
5.1
Connection to the ECU
For mounting the ETK-T2.2G on the ECU an Advanced Interconnect socket is
required. It need to be ordered separately (refer chapter "Ordering Information"
on page 54).
Fig. 5-1
ETK-T2.2G Connection to the ECU
The ETK-T2.2G board fitted with a "BGA adapter" connector allows connection
and removal from an ECU development PCB which has been fitted with a com-
patible "BGA receiver" socket (see Fig. 5-1).
Fig. 5-2
ETK-T2.2G with Microcontroller mounted on ECU
CAUTION!
The ETK can be damaged or destroyed!
Some components of the ETK may be damaged or destroyed by elec-
trostatic discharge. Please keep the board in its storage package until
it is installed.
The ETK should only be taken from its package, configured, and
installed at a work place that is protected against static discharge.
CAUTION!
Risk of short circuiting the internal signals of the ETK!
When you mount the ETK to the ECU, you must ensure that the
screws and washers used will not penetrate the ETK printed circuit
board.
