BR_XETK-S2.0 - User’s Guide
14
ETAS
Introduction
3
Introduction
This section contains information about the basic features and applications of
the ETK-T2.2G Interface Board (ETK = Emulator Test Probe), hints to system
requirements for operating the ETK-T2.2G, and other details.
3.1
Applications
The ETK-T2.2G is an emulator probe especially for the Infineon AUDO-NG
TC1798 microcontroller in the LFBGA512 housing. It fits into an ECU with an
LFBGA292 socket for the Infineon AUDO-NG TC1791 microcontroller.
Fig. 3-1
ETK-T2.2G
It is compatible with the ETAS calibration and development system interface (e.g.
ES690, ES590, ES591, ES592, ES910 and ES1000.2/ES1000.3 with ES1232-A).
Earlier systems (e.g. MAC2, ES1000.1 with ES1201 board) are not supported.
3.2
Features
• Applicable for AUDO-NG TriCore TC1798 with external 32-bit bus
• Supports 32-, 16- and 8-bit access to the data emulation memory
• CPU bus interface voltage 2.5 V compatible (3.3 V tolerant)
• Two pages of data emulation/measurement data memory available, each
with 1024 kByte
• Permanent storage of emulation data in flash memory
• Supports "Braindead Flash" function
• Provides a JTAG connector to adapt a debugger
• Serial interface with 100 MBit/s to the calibration and development sys-
tem
• ETK chip select configuration bridge
• Permanent storage of configuration in EEPROM
• ECU flashing via ETK
• Firmware update (programming of the logic device) through software;
removal of ETK or ECU not necessary.
