ETAS
Getting Started
ES420.1 - User’s Guide
43
6. Screw the screw from the right-hand side of the component
into the module.
Both parts are now completely connected mechanically.
5.2.5.4
Connecting to Other Modules
You can attach several ES400 modules to the other component using the
method described in this chapter if you first connect all modules to be installed
with each other step by step (see section 5.2.2 on page 35). The module on the
extreme right of the module block is connected to the other component like an
individual module - using screws.
5.2.6
Attaching ES400 Modules on DIN Rails using Screws
With the integrated assembly elements of the ES400 modules, you can not only
connect the modules with each other, but also with DIN rails.
For this fastening variant, you connect the ES400 module with the DIN rail using
an ES4xx angle bracket (right) and two additional M3 screws inserted through
their bores. The integrated assembly elements of the module are not used.
Fasten the ES400 modules on DIN rails with the integrated assembly elements
using the following steps:
1. Connect the module with additional modules
(as required).
2. Connect the module with the ES4xx angle bracket (right).
3. Connect the ES4xx angle bracket with the DIN rail.
Fig. 5
-
11
Fastening on DIN Rails with Additional Screws
TIP
Screw the two parts together without getting them off-
thread!
TIP
If a module has been screwed to the other component, no other modules can
be screwed to this module component connection.