Etac Prio 13420305, Manual

Page: 28 / 44

28
Etac / Prio / www.etac.com
± 2,5 cm
5 mm
6 mm
20 Nm
19 mm
VIDEO
VIDEO
Disassembly/assembly of the castor wheel
Loosen screw, nut and spacers and mount the wheel in correct
position.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Height adjustment front
The chassis undercarriage must always be horizontal. When adjusting
the seat height, it is therefore also necessary to adjust the castor
wheel position in the fork or change the castor/fork (see Section ”Seat
height table) .
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Disassembly/assembly of the front fork
1. Remove the nut cover and disassemble/assemble the front fork
with the castor wheel in accordance with the illustration.
NB! It is important to ensure that the ball bearings and washers in the
attachment (under the retaining nut) are placed in the right order with
the spring washer on top.
During installation, tighten the retaining nut until it comes to a stop
and then release by ½ – 1 turn. The spring washer then has the
correct tension and reduces the risk of the castor starting to "wobble".
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Height adjustment front fork housing
With a 6.5" castor wheel, the front fork housing must be height-
adjusted in certain rear wheel positions. Loosen the screw that holds
the front fork housing and adjust the height so that the lower tube of
the chassis is parallel to the floor.
Tighten the screw again.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
14. Advanced settings, adjustments
VIDEO
VIDEO