Removing operational components
Looking at the camera that is used more often with the coffee machine (metal lever
C
, drip
tray
E
), proceed as shown in Fig. 1. Proceed in reverse order to put the components back.
Rinsing the coffee maker
At the first start-up or if you have not used the coffee machine for more than 2 days, flush it
using the following procedure:
1.
Fill tank
D
with water up to the MAX mark.
2.
Place lever C and the stainless-steel bowl (
C2
/
C3
) on the coffee machine as shown in
Figure 1.
3.
Connect the machine to the mains. network (an acoustic signal will sound and the
backlight of buttons
B1
-
B4
will flash) and press button
B4
. The backlight on button
B4
lights up and the backlight on buttons
B2
and
B3
flash (the coffee machine is warming
up). Illuminates continuously when the backlight
B2
and
B3
light up. Make sure that the
rotary control
A1
is in the „
“ position.
4.
Once the coffee machine is warm, press the
B2
/
B3
button and let the hot water to flow
through the machine.
5.
To flush the steam nozzle, first press button
B4
(if you have not done so before) and
then turn the regulator
A1
to the „
“ position (hot water function). When you want to
stop the flush, turn the regulator
A1
to the „
“ position.
Note
–
When flushing out the coffee machine, collect the water into the drip tray
E
or into a suitable cup. Empty the drip tray regularly.
–
–
You can cancel the flush at any time by pressing the button
B4
.
IV. USING THE APPLIANCE
Remarks
–
Pressing any button is accompanied by an acoustic signal.
–
When making coffee, the coffee machine automatically has a coffee brewing function
that cannot be switched off.
–
It is important to distinguish between the backlighting of the buttons
B2
and
B3
slowly
and quickly. Slow means warming up, rapid overheating of the unit. If the unit is
overheated, the program cannot be started with the buttons
B2
and
B3
and must be
cooled, see cooling function.
–
Automatic shut-off after 25 minutes of inaction.
PREPARATION OF EXPRESSO
1.
Switch on the coffee machine by pressing button
B4
and wait for it to warm up.
2.
Place the stainless-steel bowl (
C2
/
C3
) in the funnel
C1
of lever
C
.
3.
Fill the stainless-steel bowl (
C2
/
C3
) with ground coffee to the brim with a measuring
cup
F
. Smother the coffee properly with the stamper (back of the measuring cup
F
)
intended for this purpose.
4.
Place the lever
C
on the coffee machine as shown in Fig. 1.
5.
Place a suitable size cup / cups under the coffee spout.
6.
Press
B2
(for two cups - default 60 ml) or
B3
(for one cup - default 30 ml).
7.
Wait for the coffee to finish (an acoustic signal sounds).
GB
23 / 43
