eta Quatro blade 058 Series, Instructions For Use Manual

Page: 21 / 44

– Do not wind the power cord around the appliance; this will extend its life.
– The power cord must not be damaged with sharp or hot objects, open fire; it must not be
sunk into water or bent over sharp edges.If you need to use the extension cord, it has to
be uncorrupted and it has to comply with the valid standards.
– Never use the appliance for any other purpose than for that described in these
instructions for use!
– The producer does not undertake any responsibility for damage caused by improper use
of the appliance and the accessories (e.g. f ood deterioration, injury by knife edge,
fire, etc. ) and its guarantee does not cover the appliance in the case of failure to comply
with the safety warnings above.
- All text in other languages and pictures shown on the packaging, or the product itself, are
translated and explained at the end of this language mutation.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – drive unit
A1 – switch, speed I or II (ON)*
A2 – power cord
B – mixing adapter
B1 – plastic stick blender (only for type ETA 1058; 2058)
B2 – stainless steel stick blender (only for type ETA 3058)
C – beater (only for type ETA 2058, ETA 3058)
C1 – gear
D – chopping container lid (only for type ETA 2058, ETA 3058)
E – chopping container (only for type ETA 2058, ETA 3058)
E1 – central shaft
F – mixing container (only for type ETA 2058, ETA 3058)
F1 – lid/anti-slip base
G – sickle-shaped knife
(only for type ETA 2058, ETA 3058)
* The motor is working until the switch is pushed.
III. PREPARATION FOR USE
Remove all the packing material and take out the accessories. Remove all possible
adhesion foils, stick-on labels or paper from the appliance. Before the first use, wash the
parts that will be in contact with food in hot water with detergent, rinse thoroughly with
clean water and wipe it dry.
Mounting and removal of the mixing adapter (B)
Slide mixing adapter B to drive unit A , then fix it by turning it (Fig. 2). Remove the adapter
in the opposite direction.
Mounting and removal of beater (C, C1)
Slide the shaft of beater
C
to gear
C1
, then slide the gear to drive unit
A
and fix it by
turning it (Fig. 3). Remove the adapter in the opposite direction.
Mixing container (F) and lid (F1)
You can use lid F1 either as a lid for container F if you want to store food (e.g. in a fridge)
or you can use it as an anti-slip base if you set the lid on the container bottom (Fig. 6).
Chopping container (E) and lid (D)
Set lid D on container E so that the blocking pressed holes on its edge snap directly in the
blocking protrusions in the container. When you take the lid out, use the opposite direction.
21
GB
/ 41