eta Granny 1127, Instructions For Use Manual

Page: 22 / 56

Set the temperature regulator B2 into “ 100 “ position and the timer regulator B3 into “ ON ”
position (indicator
B4
indicating heating). Wait until the water reaches boiling point and let
it boil for at least 10 minutes. Let the appliance cool off and pour out the water. Potential
short and moderate smoke or smell is not a fault and a reason for taking the appliance
back. Place the appliance on a solid flat and dry surface (e.g. kitchen table), out of reach of
children. If you are going to use the appliance for preserving in jars, insert the removable
grid
A5
and fill the container with sufficient volume of water, depending on the character
and amount of the prepared food. Plug the fork of the power supply A6 in the el. plug. The
preserving pot is now ready for use.
The operation of the ETA preserving pot is easy and consists of two main control features.
It is the temperature regulator B2 and timer regulator B3 . When finishing or discontinuing
the heating process, turn off the appliance by turning both of the regulators counter-
clockwise into „ OFF /
o
C ” position. Turn the switch B1 to position “ O “ (indicators light will go
off), and disconnect the power cord from the wall socket.
Over-heating protection
The preserving pot is equipped with a safety heat switch which will disconnect the heating
body in case of insufficient or no amount of water. If the preserving pot does not work after
having been connected to the el. outlet, in the lower part press button A7 .
Temperature setting
The appliance is equipped with an in-built thermostat, which enables you to set the
temperature from approx. 30 °C to 100 °C (boiling point) with ± 8 % accuracy. When
reaching the set temperature, it is automatically maintained (depending on the setting of
the timer).
Setting the timer
Timer regulator B3 can be used in two modes.
a) automatic mode „ 20 – 120 “
The timer enables you to set time in the range of 20 – 120 minutes. To increase the time
desired, turn the regulator clockwise. To decrease it, counter-clockwise. When the set time
runs out, the appliance turns off and a signal (1 beep) will sound.
b)
mode of continuous operation „ ON “
In this mode, the heating is not time limited. It is suitable for heating food, which needs to
be kept at a certain temperature longer than 120 minutes. You can set the mode by turning
the regulator counter-clockwise into the “ ON ”. Do not turn the appliance on without water.
Do not leave the appliance running unattended and keep an eye on it throughout the entire
food preparation process!
c)
mode „ OFF “ the timer is off.
NOTE
– T he appliance is equipped with a reached temperature indicator switch B1 . If you
turn it on (position “ I ”), the appliance will beep loudly to give you notice about the
temperature being reached. This is good especially when you need to count down
exact time of heating from the point when the pot reached the set temperature. You can
thus avoid the time difference caused by time when the pot is only heating (the time to
reach the set temperature is individual and depends on the volume of water, ambient
temperature etc.)
!
GB
22 / 51