Container (B) assembly process
Assemble the
B
container according to Fig. 1. To disassemble the container, apply the
reverse procedure.
Putting the container (B) on the driver unit (A)
Put the container
B
on the driver unit
A
according to Fig. 1. Make sure that the locking
recesses of the plastic base
B1
will fit into the locking projections of the driver unit
A
. If the
container is properly fit, the safety catch will be released, and the appliance is ready for
use. Apply the reverse procedure to remove the container.
IV. USING THE BLENDER
Consider these following tips for processing examples and inspiration whose purpose is
not to provide a manual but to show ways of different food processing. From time to time,
we recommend pausing the operation, turning the appliance off and removing parts of
ingredients which have stuck on the knife or the dish, lid. The blender is intended for mixing
juices, milk shakes, soups, baby and diet food, airy doughs, puree, etc. Pour or put the
ingredients into the dish
B
and close the mixer with the lid
C
.
Switch on the mixer by setting
the required speed between
MIN
and
MAX
.
Recommendation
–
If you process big amounts of food, divide them in separate portions so that you do not
overload the motor unit.
–
It is better to cut solid ingredients in smaller pieces.
–
Soak hard ingredients in water before processing (e.g. legume, soy beans etc.).
–
Liquid ingredients (e.g. oil, milk) or other ingredients may be added to the container
after taking out the plug
C1
through the small opening in the lid (when the engine is
operating). We recommend leaving the plug in so that liquid ingredients do not splash
out through the feeding opening.
–
The longer you process the ingredients in the blender, the finer the result will be.
–
Never fill the container with liquids which make foam (e.g. milk) up to 1500 ml so that
they do not overflow. In this case we recommend amounts approx.
1000
ml.
–
If you are not satisfied with the result, turn the appliance off, stir the ingredients using
the spatula, remove part of the ingredients or add some liquid.
–
Times of preparation (processing) depend on amount, kind and quality of substances
used, normally they are in tens of seconds.
i
V. STORAGE
After cleaning, store the appliance in a dry, dustless, safe place, out of reach of children
and persons sui juris. Wind up the power cord inside the compartment in the lower section
of the driver unit.
vI. MAINTeNANCe
Do not use coarse and aggressive cleaning agents (e.g. sharp objects, scrapers,
diluting agents or other solvents).
Clean drive unit with a soft and wet cloth with a little
detergent. Clean all accessories in hot water with a detergent right after use (do not use
a dishwasher). We recommend filling the container with warm water and a small amount of
detergent, and turn on the appliance at the maximum speed for 1 minute.
21
GB
/ 37