eta 13180LP-T, Operation

Page: 13 / 88

Empty the ash bins
13
4 Empty the ash bins
Stop heating
End the boiler's heating mode with the On/Off switch
in the boiler overview window. The boiler
performs an ember burnout and then changes to
[Switched off] mode. Press the [De-ash]
button to
make the boiler perform a final de-ashing.
Remove excess ash from secondary combustion
chamber
Open the combustion chamber door and use the poker
to scrape the excess ash into the combustion
chamber.
The ash in the secondary combustion chamber
may not be steeper than 45°.
To remove this ash, initiate boiler de-ashing by
pressing the [De-ash]
button.
Empty ash bins, check seals
The sight glass can be used to check the fill level
of the ash bins without opening them.
Fig. 4-1: Sight glass
To remove the ash bins, pull the lever on the side
towards the ash bins to release them. Remove the ash
bins from the boiler.
Close the covers in the ash bin lids and fasten them
with the wing nuts.
Fig. 4-2: Covers
Open the fasteners on the lids and empty the ash bins.
Fig. 4-3: Check ash
If there are large pieces of slag in the ash, the
combustion chamber and the tilting grate must be
checked and the de-ashing interval reduced, if
necessary.