–
The appliance is equipped with a thermal cut-out that will interrupt power supply,
if the appliance dangerously overheats. If overheating occurs, switch off the appliance,
disconnect it from the power supply, remove any obstacles preventing the air flow, and let
the appliance cool down for about 10 minutes. If the cut-out occurred for reasons other
than air flow reduction, have the appliance repaired by a specialised service centre.
– Do not modify the appliance surface in any manner (e.g. by
self-adhesive wallpapers,
foils
, etc.)!
–
When handling the appliance, avoid causing any injury (e.g.
burns
).
Do not move hot appliance, wait until it cools down!
– Only use original components designed for this type.
–
Check the condition of the power cord of the appliance regularly.
– Never put the power cord on hot surfaces and never let it hang over table edge or worktop
edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn and fall
down, causing a serious injury!
– Avoid winding the power cord around the appliance, otherwise the power cord service
life would be reduced.
– If you need to use an extension cord for justified reasons, it must be undamaged
and comply with the applicable standards.
– Only use this appliance for the purpose it was designed for, as specified in this manual.
Never use the appliance for any other purpose.
–
WARNING:
There is a risk of injury when the appliance is not used correctly
(not in accordance with the manual).
–
All texts in foreign languages and pictures shown on the packaging or the product itself,
are translated and explained at the end of this language mutation.
– The manufacturer assumes no responsibility for any damage caused by improper handling
of the appliance and its accessories (e.g.
electric shock, fire
), and the appliance guarantee
will become void if any of the aforementioned safety instructions are not observed.
II. DESCRIPTION OF THE APPLIANCE
(Fig. 1)
A – Convector (ETA1624)
A1 – Hot air outlet
A5 – Multifunctional rotary switch
A2 – Removable base
A6 – Display
A3 – ON/OFF switch of the convector
A7 – Light indicators of functions
A4 – ON/OFF switch of the set function
B – Convector (ETA0624)
B1 – Hot air outlet
B3 – Power switch
B2 – Removable base
B4 –Thermostat regulator
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the appliance.
Remove all possible adhesion foils, stick-on labels or paper from the appliance.
Installation
The appliance is only intended as a portable heater for occasional use.
Please observe the safety warnings and the instructions provided below:
GB
17 / 55