eta 0607, User Manual

Page: 16 / 36

III. INSTRUCTIONS FOR USE
Before first use, remove any packaging and protective material (including any protective film)
from the appliance and accessories.
INSERTING THE BATTERIES
The batteries must be inserted into the fan before the first use (2x Li-ion 18650, 2000 mAh) .
Remove cover A8 and insert the batteries. Observe correct polarity. Then put the cover back
and secure with two small screws. The batteries and the screws are included.
CHARGING AND POWER SUPPLY
The fan can be operated in two modes: mains supply (connected to external power source)
and battery supply. Use only a suitable power source (complying with required device
parameters) for charging/feeding (see section I. SAFETY WARNINGS). Battery charging
time is approx. 5-7 hours. A fully charged battery allows approx. 20 minutes - 10 hours of
operation (depending on set functions and their intensity (blowing air and LED illumination).
NOTE
The time indicated above refers only to a new and fully charged battery. With time
and wear, the battery capacity is reduced.
CONTROL
Switching on/off the fan + air blowing speed adjustment
Use button B2 to switch on/off the fan and adjust the air blowing speed:
1st pressing–switching on the fan, low air blowing speed;
2nd pressing–switching to medium air blowing speed;
3rd pressing –switching to high blowing speed;
4th pressing–switchig off the fan.
Switching on/off LED illumi adjustment of LED illumination intensity
Use button B3 to switch on/off LED illumination and adjust its intensity:
1st pressing– switching on LED illumination, low intensity;
2nd pressing–switching to LED illumination, high intensity;
3rd pressing – switching off LED illumination.
Remark
Air blowing and LED illumination functions can be used either in parallel or separately.
Oscillation settings
Press the B1 button to turn oscillation on. Press the B1 button again to turn oscillation off.
During oscillation, the fan rotates at an angle of about 40°-50° (back and forth).
IV. MAINTENANCE
The appliance only requires surface maintenance. Use damp cloth for cleaning fan surface
and USB cable.
16
EN
/ 30