eta 0607, User Manual

Page: 15 / 36

– This appliance is not intended for outdoor use.
– The appliance cannot be used in bathrooms in zones 0, 1 and 2 HD 384.3 S1! It must
not be used in close proximity of bathtubs, a shower or a swimming pool.
– The appliance must not be used in damp or wet environment and in any environment with
the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and
other flammable or volatile materials are stored).
– Use the appliance in the working position only at places with no risk of turning over and in
a sufficient distance from objects (such as curtains, drapes, etc. ), heat sources
(e.g. fireplace, heater, stove, cooker, radiators, hot air ovens, grills ) and wet surfaces
(e. g. sinks, wash basins ).
– Make sure that impurities do not enter into the appliance (e.g. clouds of dust, hair etc. ).
– Do not put the switched on fan on soft surfaces (e.g. on a bed, towels, wipers, carpets ).
– There must not be any device with open flame in the flow of the air coming out from the
appliance because of danger of burning process interruption.
– Never let the flow of air blow on you (or animals) for an extended period of time. It may
cause health problems.
– Never place the USB power cable onto hot surfaces and do not leave it hanging over the
edge of a table or worktop. If someone, e.g. a child, brushes against the cable or tugs at it,
the appliance might overturn or fall down and it might result in a serious injury!
– The USB power cable must not be damaged by sharp or hot objects or open flame, it must
not be submerged in water or bent over sharp edges.
– Use this appliance only for the purpose for which it was designed as specified in this user‘s
manual. Never use the appliance for any other purpose.
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire ) and its guarantee for the appliance
does not apply in the case of non–compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE
A – Drive unit
A1 – Adjustable joint angle
A2 – Base
A3 –Stand
A4 – Plastic propeller guard
A5 – Propeller
A6 – LED illumination
A7 – USB cable port
A8 – Battery box
B – Control panel with LED indicating lights
B1 – " " oscillation adjustment button
B2 – " " speed setting button
B3 – " " LED illumination adjustment button
B4 – Signal lamps – speed adjustment
B5 – Signal lamp – charging/power supply
C – Micro USB cable
EN
15 / 30