eta 0209, Instructions For Use Manual

Page: 39 / 80

39
GB
/ 75
VII. INSTALLATION, VENTILATION
1) Remove all packaging material, remove the accessory. Remove all adhesive foils,
stickers or paper from the appliance. Place the turning table on the turning circle
in the middle of the oven.
2) Place the MW oven on a desired firm and flat surface (e.g. kitchen desk or a specially
designed stand for MW ovens) at the height of at least 85 cm and out of reach of
children. The glass of the door could heat up to a very high temperature. Leave space
above, behind and next to the oven for proper ventilation (pic. 1). Openings in the
appliance provide airflow during ventilation and must not be covered or blocked. Also,
the feet of the oven must not be removed. Covering the openings or removing the feet
may cause damage to the MW oven.
3) Make sure that the supply cord is not damaged and does not go through the oven or
through any other sharp or hot places. The el. outlet must be easily accessible in order
that the oven can be easily disconnected from the el. outlet in case of danger.
The appliance is equipped with a supply cord with protective conductor.
The fork must
be plugged into a properly wired and grounded socket according to EN!
We recommend using an individual electric circuit with a safeguard
16 A
.
4) Do not remove the light brown coverthat is attached to the oven cavity to protect the
magnetron.
5) Place the oven as far away from radios and TV as possible. Operation of microwave
oven may cause interference to your radio or TV reception.
1
TURNTABLE INSTALLATION
a) Open the oven door and insert the turnable ring.
Put the glass tray on the top of the turntable ring,
so that the central point of the glass tray sits on
the turntable shaft at the bottom of the oven.
b) Never place the glass tray upside down. The
glass tray should be restricted.
c) Both glass tray and turntable ring assembly must
always be used during cooking.
d) All food and containers of food are always placed
on the glass tray for coking.
e) If glass tray or turntable ring assembly cracks or
breaks, contact nearest autorized service center.