ESX QUANTUM Q-ONEv2, User Manual

Page: 8 / 32

8
Please read the user‘s manual carefully before the installation and the first operation of the amplifier.
SPECIFICATIONS Q-ONEv2 (12V) Q-ONEv2 (24V)
Output Power RMS
Output Power Max.
Loudspeaker impedance
Frequency Response
Total Harmonic Distortion
Signal-to-Noise Ratio
Input Sensitivity
Input Impedance
Subsonic Filter
Lowpass Filter
Phase Shift
Bass Boost
Low Level Inputs
High Level Inputs
Auto Turn On
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
1 x 300 W @ 4 Ohms
1 x 500 W @ 2 Ohms
1 x 700 W @ 1 Ohm
1 x 600 W @ 4 Ohms
1 x 1000 W @ 2 Ohms
1 x 1400 W @ 1 Ohm
1 – 8 Ohms
10 – 250 Hz (-3 dB)
< 0,1 % (80 Hz)
> 90 dB
0,2 – 6 V
20 kOhms (High Level 20 Ohms)
10 – 50 Hz @ 12 dB/Octave
30 – 250 Hz @ 24 dB/Octave
0 - 180°
0 - 12 dB @ 45 Hz
2 x RCA
Via enclosed Cable Jack
Only via High Level Inputs
+12 V (10 – 16 V), negative ground
2 x 25 A
150 x 50 x 220 mm
1 x 300 W @ 4 Ohms
1 x 500 W @ 2 Ohms
1 x 700 W @ 1 Ohm
1 x 600 W @ 4 Ohms
1 x 1000 W @ 2 Ohms
1 x 1400 W @ 1 Ohm
1 – 8 Ohms
10 – 250 Hz (-3 dB)
< 0,1 % (80 Hz)
> 90 dB
0,2 – 6 V
20 kOhms (High Level 20 Ohms)
10 – 50 Hz @ 12 dB/Octave
30 – 250 Hz @ 24 dB/Octave
0 - 180°
0 - 12 dB @ 45 Hz
2 x RCA
Via enclosed Cable Jack
Only via High Level Inputs
+24 V (20 – 32 V), negative ground
2 x 15 A
150 x 50 x 220 mm
All Specifications are subject to change
INTENDED USE
Q-ONEv2 (12V) is only suitable for use in a vehicle with 12 volts negative ground voltage. Q-ONEv2 (24V) is only
suitable for use in a vehicle with 24 volts negative ground voltage.
PROTECTION CIRCUIT
The POWER LED (Fig. 2,7) lights up green, if the amplifier is in operation.
The PROTECT LED (Fig. 2,7) lights up red, when the amplifier is overheated, or a short circuit occurs respec-
tive a too low impedance load is connected to the speaker outputs. If this events, the internal built-in protection
circuit shuts down the amplifier automatically. The amplifier should work again properly after you have solved
the problems.