ESWOOD OPERATING MANUAL ES-32 June 2011
8
I
NITIAL START
-
UP PROCEDURE
5
1.
With the rotary switch and isolator “OFF”, and the hot water
supply to the machine turned on, check that the break tank is
full.
The water level should be approximately 20mm below the
overflow slot in the rear of the tank. The level can be inspected
by removing the lid from the break tank.
2.
With the rotary switch still off, turn the power on at the isolator.
3.
Check that the drain overflow is pushed into the drain hole at the
bottom of the wash tank.
4.
If the machine is fitted with an automatic detergent injector,
place the free end of the 10mm clear plastic tube, located under
the machine, into a 4 Litre or other suitable container of liquid
detergent. The unit will prime itself after a few cycles.
Do not use wrong products as they will void the warranty, and
use
product
in
accordance
with
the
manufacturers’
recommendations.
5.
With the hood open, turn the rotary switch to “FILL” and close
the hood. The machine will begin filling and the pilot light will
illuminate until the cycle is complete. Open the hood and check
that the water is up to the overflow level (at or near top of the
drain overflow pipe). If not, repeat the “FILL” cycle until the
overflow level has been reached.
6.
Open the hood and select the “L” long or “S” short wash cycle
using the rotary switch on front of Control Panel. Place the
perforated strainer pans on each side of the lower wash arm.
7.
Close the hood to start the wash cycle. The pilot light illuminates
until the cycle is complete. When finished, check for leaks.
8.
Turn the rotary switch “OFF”, open the door and remove the
strainer pans and overflow tube to drain the machine.
9. Replace the lower front panel.