7
5 . When you are finished with the recording, press the
Stop button .
6 . To save the program, hold the
Programs button and the program number button (1-6)
simultaneously (approximately 3 seconds) . For example, if you want to save it as program number 3,
press the
Programs button and the 3 at the same time .
7 . The display will show the program number and time duration once it is saved .
8 . To choose a saved program, press the corresponding program number and then press the Start/
Pause button to begin the program .
*Any current program can be reprogrammed by saving over the program number at any time without needing to
clear it.
CLEAR THE SAVED PROGRAMS
In order to clear out the saved programs in the mixer, simultaneously hold down the
Program and the
Stop keys for 5 seconds . The digital display will flash, “--“, and then return to the normal display after 3
seconds . This is a signifier that all saved programs have been cleared from the unit .
COUNTDOWN TIMER AND REMINDER
When the countdown is less than 15 seconds, the alarm will sound to notify the user every 2 seconds
until the timer reaches 0 . The motor will stop running automatically and the digital display will flash to
show “00” . Once the timer reaches zero, the alarm will sound once every 10 seconds for 1 minute .
POWER OFF MEMORY
If the motor loses power during operation, the controller will restore the program and the remaining
running time before losing power next time when the motor is powered on, but the motor will change to
the suspended state
MIXER SPEEDS:
Speed 1: Slow Mixing/Beating – For slow beating, mashing and kneading yeast dough .
Speed 2: Medium Mixing – For mixing cookie and cake batters .
Speed 3: Medium Beating – For beating , creaming and medium fast whipping .
Speed 4: Fast Beating – For whipping heavy cream, egg whites and boiled frostings .
Speed 5: Fast Whipping – For whipping small amounts of heavy cream and egg whites .
HOW TO INSTALL A BOWL
The bowl must be installed before the agitator . To install the bowl, fully lower the bowl support . Position
the bowl so the alignment bracket on the back of the bowl is in the bowl retainer and the locating pin on
the front of the bowl support fits in the holes on the sides of the bowl .
