5
SPEED INDICTOR BAR: The speed indicator bar displays which speed (1-5) the mixer is currently set to .
If the mixer senses that there is an uneven load in the mixer bowl, a notification will flash on the display .
DIGITAL DISPLAY: The digital displays are divided into two sections . The left single-digit display is the
program display area, which is used to display the current set program number . The right two-digit
display is the time display, which is used to show the time in minutes, or in seconds if the timer is less
than 1 minute . If the time is shown in minutes, a dot on the timer display will flash to signify that it is still
counting . If a program is not selected and the timer is not set, it will count up from 0 and the program
display will show 0 . If the timer is above 99, the program display will show "-", indicating a countdown
If a program is selected the program display area will display the current program number (1-6) and the
time display area will display the remaining time that corresponds to the specific program . The timer will
always count down based on the program that is selected
BUTTONS: The buttons on the control panel are as follows:
Start/Pause – Begins or pauses the mixer’s motor
Stop – Stops the mixer’s motor
Timer Up Arrow – Increases the amount of time on
the timer
Timer Down Arrow – Decreases the amount of time
on the timer
Speed Up Arrow – Increases the speed of the motor
Speed Down Arrow – Decreases the speed of the
motor
Programs – Used to create or select from preset programs
Program Selection Numbers (1-6) – Chooses the program that corresponds to the respective program
number
CONTROLS
NOTE: New mixer bowls and agitators (beaters, whip, and doughhook) should be thoroughly washed
with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and
thoroughly rinsed with clean water BEFORE being used . This cleaning procedure should also be
followed for bowls and agitators before whipping egg whites or whole eggs .
CONTROL PANEL
