5.
Install and glue aileron, elevator and rudder plywood
horns with
thick CA
. Apply thin CA to the horns for
reinforcing.
6.
Glue canopy and temporary Assemble wings to align
tail feathers.
7.
Glue stabilizer and vertical fin to the fuselage
with thick
CA.
(Horizontal tail must be paralleled with wing and
vertical fin must be at right angle to horizontal tail.)
8.
Insert elevator and rudder pushrod to the horn and then
glue hinges with small amount of thin CA.
9.
Insert landing gear, cover landing gear retainer(G5) and fix
with screws. Assemble dummy landing gear with silicon tubes,
holders and landing gear struts. Fix wheels with wheel collars.
10.
Install and glue neodymium magnetics with thin CA. Use
scotch tape on the other side as a hinge of hatch.
11.
Install elevator and rudder servos.
12.
Install aileron and flap servos.
Above servo installation shows for 6channel receiver.
5channel receiver
aileron(Y-extension), elevator, throttle, rudder, flaps(Y-extension)
6channel receiver
aileron1, elevator, throttle, rudder, flaps(Y-extension), aileron2(mixed).
7channel receiver
aileron1, elevator, throttle, rudder, flap1, aileron2(mixed), flap2(mixed).
Page 8
Summary of Contents for AIR TRACTOR AT-802
Page 10: ......
