1/5/2007
EAG Gateway Series Administration Guidelines
MAG-06007 Rev. A
5.3 System Config
In this section you input the basic information such as EAG RTP port, dialing time, DTMF mode, and
the default codec.
After logging in, click
System Config
link on the left of the web configuration page, and you will see the
following:
Note:
For information on how to use Submit and Default, see 5.2.
Figure 15. System Configuration Interface
Software Version
Software Version field value is automatically detected. You do not need to change this field.
Harware Version
Hardware Version field value is automatically detected. You do not need to change this field.
DSP Version
DSP Version field value is automatically detected. You do not need to change this field.
RTP Port Min and Max
In the RTP Port Min field enter the minimum value of sending and receiving RTP port.
This is a
required field. It is recommended that you enter a value that is greater than 10000.
In the RTP Port Max field enter the maximum value of sending and receiving RTP port.
This is a
required field. It is recommended that you enter a value that equals “2 x number of lines + the minimum
value”.
Note:
A VoIP call uses two RTP ports: one for RTP and the other for RTCP. If EAG has four lines (FXS
or Trunking lines) then the RTP port is set to eight ports at least. If RTP has less than eight ports,
four lines can not be used at the same time. The default minimum value is 10010~10030. You do
not need to change it.
28