9
Fig. 33A
Fig. 36
Fig. 34
Fig. 35
Fig. 37
Fig. 38
Fig. 39
Fig. 33B
Fig. 41
Fig. 42
Fig. 40
CARTRIDGE REPLACEMENT
(10-0186)
Refer to the exploded view of the
eSpring
®
Water Purifier for assistance
with part names (See inside front cover).
1. Unplug the Power Adapter from
the wall outlet.
2.
Turn off
water to Water Purifier.
a) If using the Diverter,
turn off
the kitchen faucet and place the
Water Purifier in the sink. Pull the metal pin on the Diverter to
drain water (Fig. 33A).
b) If using the Auxiliary Faucet,
turn off
the cold water supply using the shut-
off valve
. Turn on Faucet to drain water and
leave open
. Place
towels around the Base of the Water Purifier (Fig. 33B).
3.
Remove
the Top Shroud
. Remove
the Electronic Module
. Then,
remove the tubing removal tool
(Fig. 34).
4.
Draw
a line with an ink pen across the
top of each tube where it meets the
rings on the Water Purifier (Fig. 35).
5.
Make sure
the logo on the removal tool is facing out and the tool is flat
against the Bracket.
Firmly push
the tool against the rings with your
fingers and then pull the tubes out
with the opposite hand while rings
are depressed (Fig. 36).
NOTE: If you do not have the Removal
Tool, remove each tube by pressing evenly
with your fingertips on both sides of the
rings that surround the tubing. Then, pull
the tube out with the opposite hand.
6.
Unscrew
to remove the Retaining Ring (Fig. 37).
7.
Lift the handle
on the Bracket.
Pull
straight up
to remove the attached used
Cartridge and Bracket (Fig. 38).
8.
Unscrew
Cartridge from Bracket to
remove and
dispose
of the Cartridge in
accordance with local requirements
(Fig. 39).
NOTE: The UV lamp in the Cartridge contains
mercury. Please dispose of according to local,
state or federal laws.
9. Empty water from the Base. Then,
inspect
seal and upper interior surface of
Base and
remove
any dirt (Fig. 40).
NOTE: DO NOT allow vegetable oil, petroleum
jelly, or other lubricants, solvents, ammonia,
alcohols, acids, or strong cleaning solutions to
come into contact with the Water Purifier. They
could cause permanent damage to the Base. Use
food grade silicone (WTI-0895) on o-rings to
lubricate if needed. When cleaning, use a mild
liquid dishwashing detergent and water.
10.
Remove
the protective plastic wrap from
the new
eSpring
Cartridge (10-0186).
11.
Firmly press
Cartridge and Bracket to-
gether
.
Screw
the Cartridge onto the
Bracket until it comes to a STOP
(Fig.
41).
12.
Reinsert
the Bracket (with the attached
Cartridge) into the base by
aligning the
notches
of the Bracket with the tabs on
the Base
. With the handle down,
firmly push down
on the Bracket until it
contacts the Base
(Fig. 42).
1035793_eng.indd 9
6/10/14 4:42 PM
