i-XL Service Guide
11
3.
The Main Reference point position
3.1
General information about reference points
X
Y
Working
area
Main reference point
All X- and Y co-ordinates in the Input program file use the selected reference point as its origin.
Two modes are available:
1.
Fixed reference point – the position of the reference point is fixed on the table.
2.
Panel reference point – the position of the reference point is set by pressing the Init push button
on the Operator panel.
The fixed reference point number 1 is defined to be the Main reference point.
The Main reference point has to be correctly positioned in order to obtain:
A full working area.
Correct sheet feed operation.
Correct handling of long jobs
Using the Main reference point during program execution ensures correct operation.
3.2
Set the Main reference point for i-Cut
If you are about to run i-Cut on your table, use this procedure to set the Main reference point:
1.
Go to Option, Table setup, Set Reference point.
2.
Press the i-Cut Main Reference - button. The Main reference point is correctly positioned.
Summary of Contents for Kongsberg XL
