ESI ESI2000, Operation Manual

Page: 217 / 272

Dynamic Processing
209
CONTROLLERS ENABLE
LFO->Pitch: on
LFO->VCF Cutoff: on
LFO->VCA: on
5. Select page three by pressing the right cursor button. The third
page controls the following realtime control destinations:
CONTROLLERS ENABLE
VCA Level: on
Attack: on
Pan: on
6. Press ENTER to exit the submodule. The ESI will return to the
Module Identifier.
This function lets you to restrict the number of output channels assigned
to a zone. The “Assign Group” system allows you to assign a certain
number of output channels and designate a submix to each zone.
Zones are allowed to use output channels within their assigned group of
channels only and do not interfere with other groups. Poly All is the
default mode which allows free use of all output channels, but Poly All
will not interfere with Zones assigned to other groups. By assigning
zones in the preset to groups, important parts can be protected from
being “stolen” if ESI's polyphony is exceeded. Alternatively, a zone, such
as an open high hat, can be assigned to a mono channel bin so it will be
cancelled by a closed high hat assigned to the same group.
The modes are as follows.
• Poly All: Poly All is the default group and is used when specific
assignments are not needed. Notes are played polyphonically with
dynamic channel assignment, using all channels.
• Poly 16 A-B: Two groups of 16 channels each. Notes are played
polyphonically with dynamic channel assignment, but using no
more than 16 channels.
• Poly 8 A-D : Four groups of 8 channels each. Notes are played
polyphonically with dynamic channel assignment, but using no
more than 8 channels.
• Poly 4 A-D: Four groups of 4 channels each. Notes are played
polyphonically with dynamic channel assignment, but using no
more than 4 channels.
9. Channel
Assignment