ESI ESI2000, Operation Manual

Page: 176 / 272

168
ESI Operation Manual
10. Select the preset into which the zone will be loaded, then press
ENTER. The ESI defaults to the lowest numbered empty preset.
LOAD ZONE into
P01 Empty Preset
Select Dest Preset
If you select an empty preset, you will be given a chance to rename the
preset that the ESI just created. Choose the characters you want to
change with the left and right cursor buttons. Select the desired charac-
ters by using the ten key pad, Data Entry Control, and/or keyboard. You
can also use the up cursor to insert spaces and the down cursor to delete
spaces. After renaming is complete, press ENTER.
11. If you selected only primary or secondary samples, select
whether you want to load them into the preset as primary or
secondary samples.
This step allows you to load primary sample(s)
into secondary locations and visa versa. If in step 6 you selected
both samples, the ESI will skip this step, as these samples will
always be loaded into both primary and secondary sample slots of
the destination preset.
LOAD ZONE into
P01 pri
Select pri/sec
12. Select the key where the low key of the zone will be placed,
then press ENTER. As you select notes, the display will show the
samples mapped into the preset. After loading, the ESI returns to the
Module Identifier.
LOAD ZONE into
P01 both C1
Select New Low Key
Entire
Kybd
ZONE
Any
Range
= (Keyboard Range)
!
Caution: Loading a zone will overwrite
any previously assigned notes that overlap
with the zone being loaded.