6
VICTORY 2 LEG ELECTRIC TABLE BASE
OPERATION
GENERAL OPERATION
Move the table up or down by pressing UP
s
or DOWN
t
until
the work surface reaches the desired height.
The table will continue to move up or down until you release the
button or until the maximum or minimum height is reached.
MINIMUM AND MAXIMUM STOP POSITION
This feature can be used to limit the range of table travel to
prevent the work surface from hitting items below or above it.
• The minimum stop position must be in the lower half of the
movement range, and the maximum stop position must be in
the upper half.
• Minimum and maximum stop positions must be set separately.
To set a stop position:
• Move the work surface to the desired minimum or maximum
height.
• Press and hold both the UP
s
and DOWN
t
buttons for 10 to 15
seconds. The control unit will click twice when the stop position
has been stored.
To erase a stop position:
• Move the work surface to the stop position to be erased.
• Press and hold both the UP
s
and DOWN
t
buttons for 10 to 15
seconds. The control unit will click once when the stop position
has been erased.
SAVING A TABLE POSITION
The three memory buttons can be used to save specific positions
of the work surface. To set a specific position:
• Adjust the work surface to the position you want to save. (The
display on the control pad shows the work surface height.)
• Press the Setting button
S
. The display will read
S – –
.
• Press the desired Memory button,
1
,
2
or
3
. Let’s say you
pressed 1. The display will read
S1
.
• The work surface position is now saved. The control unit will
click twice after about two seconds and the display will show
the work surface height.
Setting
Button
Memory
Buttons
Table
Height
DOWN
Button
UP
Button
CAUTION: The “zero setting” procedure
must be completed before operating the
table. See Step 12 on page 5.
You can set a minimum stop, a
maximum stop, or both a minimum
and maximum stop.
Minimum and maximum stops can
serve the same function as memory
stops. For example, minimum stop
could be the user’s standard sitting
position and maximum stop could
be the user’s standard standing
position.
Default stop position for the three
memory buttons is the lowest height
of the work surface.
Table movement stops when you
release the UP
s
or DOWN
t
button.