4
VICTORY 2 LEG ELECTRIC TABLE BASE
ASSEMBLY
STEP 6
Adjust the position of the frame before screwing it
to the table.
• The top supports on each side should be
approximately 1" (25mm) from the ends of the
table.
• The rear of the feet should align with the rear
of the table.
STEP 7
Once in their final position, attach the top supports
and cross channels to the table.
• Use ST4.8x19 screws (8 total required).
• Attach the screws through the mounting tabs on
the cross channels and through the holes at the
ends of the two top supports.
STEP8
Tighten the M10 set screws in the cross channels
(8 total). Use the 5mm Allen key to hand tighten.
STEP 9
Attach the digital keypad using the two ST2.9x19
screws.
• Position the digital keypad on the left or right side
of the table, according to user preference.
• Align the top of the keypad with the edge of the
table so that the controls will be easily accessible.
STEP 10
Attach the control unit using two ST4.8x19 screws.
• Position the control unit near the back of the
table, on the same side as the digital keypad.
• Be sure the cable from the keypad can reach
the control unit, and the motor cables can
extend from the control unit to both motors.
ST2.9x19
Digital Keypad
Aligned with
Edge of Table
Align Rear of Feet with Rear of Table
1"
1"
Tighten
Set Screws
ST4.8x19
Control
Unit
ST4.8x19
