16
17
Figure 3:
The cable routing leads away the cable bundle.
from the coupling rods. It can be utilised on
both sides.
For this purpose, the 14-pin connector is
clipped into the front receptacle of the
cable guide. Subsequently, the cable guide
is pushed into the rear receptacle. For this,
the cable should be slightly twisted.
Cable guide
Figure 3
if necessary
cable tie
285mm
9650
L = L1 + 25mm
L = Lo + 42mm
9648
255,5mm
9647
L = Lu + 57mm
Figure 2:
Twist the lock case into the bottom milled groove and fixate it with the forend screws (1+2).
Twist the motor module into the upper milled groove while hooking it into the lock case in the process (3),
and fixating it with the forend screws (4).
Now you can check for optimal seating and
also carry out a function test. Finally, place the
blind fore-end on and fixate it (5).
4
5
2
1
3
Figure 2
10
24
18
10
76
204
232
456
476
10
20
2.2 Installation and mounting instructions
Summary of Contents for systeQ-S 765M
Page 10: ...10...
Page 20: ...70 40 564 01 01 19...