4
Adapter Installation with S95
Component Preparation
IMPORTANT:
For S110, S130 or S145 sizes, go to pages 6 and 7.
Prior to installing the Posilok tooth system components:
• Thoroughly clean all bearing surfaces on the tooth base, adapter, and pin.
• Visually inspect top and bottom of tooth base for wear, refer to the nose rebuild section for
acceptance standards.
Install S95 Pin
• For applications where soil fines pack and harden,
it is recommended that the outer sleeve of the pin
be covered in grease (see Pin Rebuild section).
• Place pin into adapter base.
Tip:
Pin can be inserted from either side of base.
Recommended corner positions should be installed
from the inside.
• If pin is not fully retracted, use hex bit to turn
head until pin body is flush with the end of the
pin sleeve.
For S95PN pin only, retract by
turning clockwise.
Sidewinder pin
S95RPN only
Install S95 Adapter
• Use appropriate lifting devices to position adapter
onto tooth base until it solidly contacts end of
base. For wear cap style, pre-assemble so that
eye on tip can be utilized as shown.
Adapter
base
Posilok
®
base
Pre-assembled for
easy lifting.
