ESCO Technologies ETS-LINDGREN SuiteSentry, Operation And Installation Manual

Page: 13 / 34

Page 13 of 34
Step Two: Remove SuiteSentry Single Snanner from the shipping/test carton:

Remove the SuiteSentry Single Screener and carefully place SuiteSentry Single Screener on
floor/horizontal surface out of the way. Carefully remove rigid foam blocks from body of
SuiteSentry Single Screener column.
Step Three: Wall Bracket Attachment:
There are two methods to attach the bracket to the wall surface. If not aligned with a stud, the “Wall
Toggler” method should be used. One toggle is used with each wall bracket. See method on next
two pages. If aligned over a stud, then use wall dog screws to attach bracket to wall.
NOTE: if there is more than 1”/2.5cm railing the mounting extension block kit can be used to bring
the detector another 1.5” off of wall face.
1.“Wall Toggler” anchor screw method
Be sure you are not over a wall stud !
Note: Pre-drill hole with 1/8” drill bit no more than 1.5” depth, then follow with ½” drill
Mounting Hole measurement and drilling

Mark the first hole location between studs at exactly 67 inches from the floor . Drill a 1/8”
hole and the use a ½” drill. The lower mounting hole must be exactly 41” below this hole and
aligned directly below it to assure the detector will be vertical and not crooked.

The strongest attachment to the wall is to use the Wall Toggler”. This is a heavy duty toggle
bolt kit included in the shipment; Part # 2186 A-02053. It requires a ½” drill bit (not provided)
and instructions are included. This is the recommended mounting when locating between wall
studs. You use the toggle bolt in the center hole of each wall bracket. See figures 6.1, 6.2,
6.3, 6.4 on Page 15.

Be precise with your measurements to ensure the brackets will line up with the side mounting
holes in SuiteSentry Single Screener column.

Wall dog(s) maybe used in addition to the togglers on the bracket if needed to ensure a tight
fit.
If toggler will not work in this location, as a last resort only, unit may be mounted with 4 wall
dog fasteners (included) on each bracket between wall studs.
2.“Wall Dog” anchor screw method (ONLY IF TOGGLER WILL NOT WORK!)
Be sure you ar e centered over a wall stud !

Mark a point at 67 inches from the floor. Drill into the wall/stud with a 1/8” drill and then attach
an anchor screw (Wall Dog) with a #10 flat washer through the bracket hole in the wall
bracket. Repeat for all four corners and then repeat for the bottom bracket. The lower
mounting hole must be exactly 41” below this hole and aligned directly below it to assure the
detector will be vertical and not crooked.

Install second bracket 41” directly below, be sure to stay plumb, and mount bracket same as
top.
TIP! Use the laminated short form instruction sheet to capture the dust
from drilling the ½” hole; you will then not make a mess on the floor!