Page 17 of 34
Mounting the SuiteSentry Single Screener Array Column into the Wall
Bracket
1.
The Sensor Array Column slips inside the mount brackets in a channel. (see Fig. 10)
2.
To fasten to the two brackets, insert the side screws through the two brackets and carefully and
gently thread into detector column.
NOTE: Do not use power tools; hand screw only so as not to cross
thread!
3.
If the distance between the wall and rear bottom cap of the SuiteSentry Single Screener is tight,
before inserting the bottom side screws
, pull the bottom of the SuiteSentry Single Screener
forward slightly and insert the Power Cable into the connector at the rear of the SuiteSentry
Single Screener.
4.
Insert the bottom cross screw in the same manner.
5.
Use the Digital Power Supply cover screws (with caps) to mount the Power Supply and Cover to
the wall near the power outlet (
but within 6-8 feet of the array).
Module should be mounted so the
green ON light is visible through the hole in the Cover using provided double sided tape and
leveled/not crooked.
6.
Trim all excess cabling NEATLY in wire molding/surface conduit provided in shipping box.
7.
Place floor mat and attach short form instructions with permission form the facility management.
Figure 11: Fastening Mounting Block
to SuiteSentry Single Screener
Figure 10: Completed Installation
Summary of Contents for ETS-LINDGREN SuiteSentry
