ESCO Technologies ETS-LINDGREN MAPS 2112 Series, User Manual

Page: 35 / 38

35
OPERATION
CAUTION: Before placing into operation, follow the safety information
in the ETS-Lindgren Product Information Bulletin included with your
shipment.
Note:
The MAPS mast assembly is incompatible with the 2112/2117 mast
assembly due to a change in the gear ratio to facilitate the higher speed of
the mast. To upgrade a standard mast to a mast, contact ETS-Lindgren.
If you are unfamiliar with the operation of the EMCenter™ Modular RF Platform (with EMControl™ Positioner Controller
Plug-In Card), see the manual, available for download from ets-lindgren.com.
With the installation of the Multi Axis Positioning System (MAPS™) complete, the controller must be connected to the
unit and power applied to both the motor base and controller. See the controller manual for information on connecting
the fiber optic cable.
Use the controller to check the clockwise (CW) and counterclockwise (CCW) rotation in both directions by a few
degrees. The position in degrees increases (+) in the CW direction and decreases (-) in CCW direction.
EMCenter Parameter Settings
Encoder calibration for the positioners is 3600 and should be entered into the configuration page on the EMControl™.
For all other parameter settings, refer to the EMControl™ Positioner Controller Plug-In Card User Manual , available for
download from ets-lindgren.com.
Note: If you are unfamiliar with the operation of the EMCenter, see the
manual, available for download from ETS-Lindgren.com.
The EMCenter replaces the 2090 Controller, which has been discontinued.
The 2090 requires firmware revision V 3.21 or higher. It is available for
download at ets-lindgren.com and requires the program Flash Upgrade
Wizard V 4.0 (also available at ets-lindgren.com).