ESCO Technologies ETS-LINDGREN MAPS 2112 Series, User Manual

Page: 19 / 38

19
ELECTRICAL INSTALLATION
Caution: Before assembling, installing, or connecting any components,
follow the safety information in the ETS-Lindgren Product Information
Bulletin included with your shipment.
Electrical installation must be performed by a qualified electrician, and
in accordance with local and national electrical standards.
Make sure the power is off and secured before proceeding.
The Multi Axis Positioning System (MAPS™) is designed to operate using 208–230 VAC single phase 50 or 60 Hz
power.
1. The branch circuit supplying power to the motor bases must be protected from excess current according to
local electrical codes. Integral circuit protection is provided in the motor base assembly.
2. Make sure the conductor size is adequate for the motor load and the distance from the mains source.
Improperly sized conductors will lead to a high voltage drop in the power conductors and cause reduced starting
torque and premature motor failure.
3. Each motor base assembly is provided with an IEC-320 power inlet for connecting to the mains.
4.
Connect the fiber optic control cable and install the power connection according to local electrical code. See the
controller manual for information on connecting the fiber optic cable. After the fiber optic cable is installed, secure it
with a wire tie to one of the leveling screws.