9.
Fascia, Log and Glass care
The Fascia is the visible surround of your Escea Gas Fireplace and must be treated carefully to prevent
unsightly marks from tarnishing the visual quality of the product. Some marking over time is inevitable
however, so the following directions will assist you in getting the maximum enjoyment from your Escea
Gas Fireplace.
NEVER, EVER RUB THE FASCIA.
The outside of an Escea Fascia must only be cleaned with a soft microfibre cloth. If heavier cleaning is re-
quired for the likes of grease or stubborn fingerprint removal we recommend the use of Steel Kleen brand
Ezi Wipes. These wipes have been tested by Escea technicians and produce very satisfying results, when
used correctly. Instructions for their use follow.
For Powder Coated Fascias:
1.
Ensure that the Gas Fireplace is off, and that the fascia is cold to the touch.
2.
Using the gloves provided with your fascia, remove the towelette from the sachet and wipe the
fascia with even, straight strokes.
3.
Because the wipe leaves a protective film over the fascia, the entire fascia will need to be wiped
to avoid seeing a difference in surface texture. Ensure this film is distributed evenly.
4.
If the film is applied too heavily and is quite visible, you can remove the excess by gently wiping
dry with a microfibre cloth
5.
Ensure that no film is applied to the glass of your Escea Gas Fireplace. If applied accidentally,
wipe off with an absorbent microfibre cloth.
Cleaning the logs / Glass (DL series):
Step 1:
If using a Velo or Rado fascia, Remove the lower trim which is
held in place by magnets
Step 2:
Lift off the inner fascia by unscrewing the base of the inner
fascia, then pulling it out and lifting it up and off.
Step 3:
Unscrew the top and side glass retainers and remove them.
Take care that the glass does not fall forwards at this stage.
Step 4:
Lift out glass and place it carefully aside.
Step 5:
Take out log set and gently brush any soot from log with a
soft hearth brush. The burner tops can be vacuumed too.
Step 6:
Clean the inside and outside of glass with normal glass
cleaning products. Use a clean dry cloth only. Stubborn marks
may be cleaned with a ceramic glass cleaner.
Step 7 :
Replace in opposite order and test run heater.
Step 2
